Socket Gasket

Complies with Fire Requirements
Tested to BS476 Pt 22

Description

The gasket is supplied in specific sizes to suit both single and double socket boxes. To fix remove tape on back of gasket, and press into place on the inside rear face of the socket box.

The Socket Gasket is designed not to impede internal wiring and can be penetrated easily for wires and cables to pass through.

Used within electrical socket boxes that are fixed into plasterboard, brick or block work where the Fire and Acoustic properties would be infringed. The gasket is designed to comply with IEE Regulations and British Standards.

Health and Safety

C.O.S.H.H sheet available on request.

The stud partition test was stopped after 132 minutes without failure